Manual, remote and automated operations
Implement condition-based monitoring and maintenance using valve status data communicated via SCADA, telemetry or downloaded from onboard memory
The mSmartWing2 controller’s ability to acquire and communicate precise data on even small changes in hydraulic pressure supports condition-based monitoring and maintenance in many ways:
Predictive Valve Maintenance
Predictive maintenance is enabled by early detection of small operational anomalies. Partial stroke testing allows diagnosis of potential valve failure without stopping production and with zero emissions. Maintenance is reduced and easier to schedule, and production delays are minimized.
Acuator Pressure Stabilization
Pressure stabilization eliminates progressive valve closure and associated wear with mSmartWing2 monitoring and automatically compensating for temperature-induced variations.
Line Break Detection
Identifies gradual losses in pressure over time preventing hydraulic releases. Deviation from the pressure gradient prompts an mSmartWing2 programmable alarm or valve closure.
Monitors and regulates ESD actuator pressure
UL 508A Listed and NEMA 1, 3R, 4 and 12 Encloser
Reduce wellsite visits
Hydraulic fluid leak detection system
Partial stroke test
Full SCADA capability and 2-way telemetry ability
Optimize flow rates with prompt choke adjustments
Available in sizes 21/16” 5K to 31/16” 10K
Base: 35x32 inches (88x80 cm)
Accuracy of measurement: +-1%
Oil volume: 2 gallon (7.57 L)
Weight: 400 lbs. (181 kg)
Internal memory capacity: 6 months minute by minute via USB
Electric power required: 120VAC
Height: 69 inches (175 cm)
Response time: +-1%
Operating temperature: -40°F to 185°F (-40°C to 85°C)
Hydraulic outlet pressure: 300 to 2,000 PSI (20 to 138 Bar)
Communications: Modbus RS485 protocall
24-hour Dispatch Number
+1 701-453-3443
info@sandpro.com
Monday-Friday
7:00 am - 5:00 pm